@stefan_21 1100 seems to be top for me.... Fan quiet at about 60% and average 1.3th/s..... at 1060.... I had extreme performance drops under 1th quite often ... temperature is kept at 60 degrees .... 1150 there the fan must turn almost 80% ....
@Testo-Investor currently have 1080 × 650... also seems to run well and is slightly above 1.3 TH/s... Temperature is stable at 65 degrees...
636 is actually not the max value. You can also turn on the "overclock" mode and then you can pretty much set what you want. I've already played around with it a bit. But it's dangerous because in the worst case you could break the device😂
@Testo-Investor yep... also ran without any problems. But I was afraid that it was too high and went back down to 650😂 But I read up a bit in the forums and apparently if you have less than 1% error shares within 15 minutes of starting, ideally 0 of course, the miner is running correctly. So you can give it a try :)
