6J·

Synchronization/updating

Hello everyone,

I have just bought an ETF that should increase the China share in my portfolio somewhat. However, when I look at the analysis here, I still have a very low China allocation. Do you know if the country allocation or something similar does not change immediately after the purchase (entry of the purchase)? Or does getquin perhaps not know which countries are in this ETF? $SEDM

5 Commentaires

Stulle 🥪@Stullen-Portfolio

Nein.

Gruß
🥪

•

André@MoneyForFun

@Stullen-Portfolio Great answer ;)

••

Dividendenopi👴@Dividendenopi

It also only has a little more than 25% China exposure itself, and then measured how large the ETF's share in your portfolio is. It is possible that this only has an impact after the decimal point or that the data provider does not transmit the composition to gq

••

André@MoneyForFun

@Dividendenopi All right. Thank you. I'll have another look tomorrow. Yes, I would certainly notice that. I specifically wanted to significantly increase the emerging market share. The figures from getquin have always been a good basis so far, but I admit that I haven't looked 1h for a purchase yet.

••

André@MoneyForFun

I had done the portfolio analysis too quickly after I had entered the purchase. The error did not correct itself. So I had to do a new analysis. Then it was correct and the share of China had increased. For all those who have also encountered this problem :) Best regards

••